STEEL KIT Wheel cover hanging bracket 4x4 spare tyre carrier with bolts and nuts

Here we have a strong metal bracket for hanging a wheel cover This can be bolted on :- Rear door of a vehicle Inside panel of a vehicle Front Bonnet of a vehicle Top Roof of a vehicle Caravans , horse carriers and SUVs/MPVs Are you fed up with having your tyre at the bottom underside or otherwise inside your vehicle? This will allow you to hang your wheel cover complete with rim and tyre anywhere on the vehicle Comes with the 3 bolts for holding the tyre in place Grab this unusual and rare item not found easily and with a bit of diy make it a great enhancement to your vehicle Going on a long journey and need an additional spare tyre (holder)? Measurements: Bottom Metal piece for attaching to the vehicle - 4 holes for bolts predrilled 8 inches (20cm ) by 6 inches (15 cm) Top Metal Piece 5.25 inches (13.2cm) x 5.25 inches (13.2cm) 3 holes predrilled with bolts and nuts supplied to hold the tyre Gap Protrusion bar between the two metal pieces welded together measures 5.25 inches (13.2 cm) PCB MEASUREMENTS The three holes pre drilled where the bolts (supplied) are put in measure as follows:- Bottom two holes have a gap of 7 cm Top to bottom left and right holes measures 11 cm Further holes can be easily drilled to suite any rim size